14-2
MAINTENANCE
14
Cleaning
DO NOT use harsh solvents such as
benzine or alcohol when cleaning,
because they will damage the transceiver
surfaces.
If the transceiver becomes dusty or dirty,
wipe it clean with a dry, soft cloth.
Replacing fuse
If a fuse blows, or the transceiver stops functioning,
nd and repair the cause of the problem. Then replace
the damaged fuse with a new, adequately rated fuse.
The fuses are installed in the DC power cable and the
circuitry in the body, to protect the transceiver.
• DC power cable fuses .......................ATC 25 A /30 A*
• Circuitry fuse ................................................. ATC 5 A
* The fuse type differs, depending on the transceiver version.
RWARNING!
• Disconnect the DC power cable from the transceiver
before replacing the fuse.
• NEVER use fuses that are not specied.
CAUTION: When you remove a fuse, use longnose pliers
to protect your ngers and the fuse holders.
D DC power cable fuses
See the following illustration to replace the DC power
cable fuses.
ATC 25 A/30 A fuse
D Circuitry fuse
1. Remove the 14 screws, then remove the cover.
2. Replace the circuitry fuse as shown below.
3. Replace the cover and the screws.
ATC 5 A fuse
To Next Page
Loading...
Need help?
General
