20
7
DIGITAL OPERATION
7
n Receiving a call
q When a call is received;
• “ ” and “ ” appears and the mute is released.
w Push and hold [PTT], then speak into the microphone at a
normal voice level.
• “
” appears.
NOTE: Only one station is permitted to speak.
e Release [PTT] to return to receive.
r To finish the conversation, push (Clear) to send the
‘Clear down’ signal.
• Either station can send a ‘Clear down’ signal.
• “STANDBY” is displayed for 2 sec. (approx.)
• “
” disappears and the transceiver returns to the standby condi-
tion.
n Ringer operation
Before starting communication, you can send the Ringer call
to announce your group station that you are going to trans
-
mit.
See p. 14 for details of the ringer procedure.
*
(S-Ring/Ringer) is replaced with
(Call) in the illustra-
tion on page 14.
q Set the desired Common ID. (pgs. 19, 39)
w Push (Call) to send the Ringer call.
• When a member of your group station answers your call, the re-
ceived transceiver emits beep tones* and “ ” appears on either
side.
• “ ” blinks on the received transceiver.
* The Ringer emission type can be selected in Set mode.
(p. 27)
e Push [PTT] to transmit; release to receive.
r Push (Clear) to send the ‘Clear down’ signal.
• Either station can send a ‘Clear down’ signal.
• “STANDBY” is displayed for 2 sec. (approx.)
• “
” disappears and the transceiver returns to the standby condi-
tion.
NOTE: This function is available only when the called
station has use the same Common ID and the same
operating channels as you.
To Next Page
Loading...
Need help?
General
