New2001
16
5
SCAN OPERATION (Except for the Dutch Version)
New2001
■ Starting a scan
1. Select a Channel Group. (p. 10)
2. Push [◄] or [►] to display
.
3. Push
.
• The scan starts.
• “ ” is displayed during a Priority Scan, and
“ ” is displayed during a Normal Scan.
L When a signal is received, the scan pauses until the signal
disappears, or resumes after 5 seconds, depending on the
Scan Timer setting in “Radio Settings.”
L A beep sounds and “16” blinks when a signal is received on
Channel 16 during a Priority scan.
4. To stop the scan, push
.
■ Setting Favorite channels
You can quickly recall often-used channels by setting them
as Favorite channels. You can set Favorite channels in each
Channel Group.
1. Select a Channel Group. (p. 10)
2. Push [▲] or [▼] to select the channel you want to set as
a Favorite channel.
3. Push [◄] or [►] to display
.
4. Push
.
• The selected channel is set as a Favorite channel, and
“ ” is displayed.
L To cancel the setting, push
again.
TIP: You can set all channels as Favorite channels, clear all
settings, or reset to the default. By default, some channels
are preset as Favorite channels. The preset channels differ,
depending on the transceiver version.
TIP: To properly receive signals, be sure to adjust the squelch to a
suitable level.
Example: Starting a Normal Scan.
Push to start
When a signal is received
“ ” and “ ” are displayed.
While scanning
“
” is displayed.
To Next Page
Loading...
Need help?
General
