■ Set mode programming
Set mode is used to change the conditions of the trans-
ceiver’s functions: scan type (normal or priority), scan resume
timer, weather alert, dual/tri-watch of COMMANDMIC, trans-
ceiver’s beep tone, internal speaker, LCD contrast, RF atten-
uation level, automatic fog horn frequency, scrambler type
and scrambler code.
Available functions may differ depending on dealer setting.
q Turn power OFF.
w While pushing [16•9], turn power ON to enter set mode.
e After the display appears, release [16•9].
r
Rotate [CHANNEL] to select the desired item, push [ENT].
Or push [16•9] to select the item when using an optional
HM-127.
t Rotate [CHANNEL] to select the desired condition of the
item. Use [
YY
]/[
ZZ
] when using an optional HM-127.
y Rotate [CHANNEL] to select “Exit,” push [ENT] to exit
set mode and returns to normal operation condition
• SET MODE CONSTRUCTION
To Next Page
Loading...
Need help?
General
