14
5
BASIC OPERATION
New2001
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
■ Adjusting the squelch level
The squelch enables the audio to be heard only while
receiving a signal that is stronger than the set level. A higher
level blocks weak signals, so that you can receive only
stronger signals. A lower level enables you to hear weak
signals.
1. Push [SQL] to enter the
Squelch Adjustment
mode.
2. Rotate [DIAL] to adjust the squelch level, until the noise
just disappears.
3. Push [16/C] to exit the Squelch Adjustment mode.
■ Using the VOX function
The VOX function automatically switches between receive
and transmit by detecting your voice.
z While holding down [SQL], push [CH/WX]*
1
or [CH]*
2
to
turn ON or OFF the function.
• “VOX” is displayed.
*
1
For the USA, Chinese, and Export versions.
*
2
For the European, UK, German, and Australian versions.
Water in the speaker grill may mufe the sound coming
from the speaker. The AquaQuake Water Draining function
removes water from the speaker grill by vibrating the
speaker cone.
L The AquaQuake Water Draining function is not usable
when using an optional battery case or the optional speaker
microphone.
1. While holding down [H/L], push [FAV] to turn ON the
function.
• “ ” is displayed.
• A low frequency vibration beep sounds for 10 seconds to
drain the water, regardless of the volume level setting.
2. Push any key to turn OFF the function.
NOTE: The optional PTT switch cable and headset are required to
use the function.
■ Using the AquaQuake water
draining function
TIP: When the AquaQuake Action setting is ON in the Set mode,
you can use the function by just shaking the transceiver within 30
seconds, after the water is detected (p. 22)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
