VI
QUICK REFERENCE GUIDE
[Using the keypad]
➥ E
nter the desired frequency
via the keypad.
• Direct input can be set until 1 kHz digit, rotate [R-DIAL] to set
below 1 kHz frequency after set tuning steps, if necessary. (See
p. 14 for setting the tuning step.)
• Pushing [VFO MHz] omits the entry of 100 kHz and below, when
you want to edit to these digits “0.”
• Push [DUALWATCH] to cancel the entry.
5. Receive mode selection
➥ Push [MODE SCAN] several
times to select the desired re-
ceive mode.
• FM, WFM, AM, LSB, USB and
CW are available.
■ Memory programming
The IC-R20 has a total of 1250 memory channels (including
200 auto write channels and 50 scan edges) for storing often
used receive frequency, mode, etc.
1. Setting frequency
In VFO mode, set the desired receive frequency mode.
• When “
µµ
” indicator is displayed, push [VFO MHz] to select the
VFO mode.
2. Selecting a memory
channel
Push [MR S.MW] for 1 sec.,
then
rotate [R-DIAL] to select the de-
sired memory channel.
•“
µµ
” indicator blinks.
3. Writing a memory channel
Push [MR S.MW] for 1 sec. until 3 beeps sound.
• Memory channel number automatically increases when continuing
to push [MR S.MW] after programming.
To Next Page
Loading...
Need help?
General
