IKEA DISKAD User Manual

28
Note:Set the water hardness determ-
ined on your appliance.
With a water hardness of 0 - 8°E you
can dispense with special salt and
switch off the water softening system.
Setting water softening sys-
tem
Set the water hardness on your appli-
ance.
1. Determine the water hardness and
the appropriate setting value.
→"Overview of water hardness set-
tings", Page27
2.
Press ⁠.
3. To open the basic settings, press
for 3 seconds.
a The display shows H:xx.
a The display shows ⁠.
4.
Press or repeatedly until the
right water hardness has been set.
The value H:04 is set at the factory.
5.
To save the settings, press
for 3 seconds.
Special salt
You can use special salt to soften water.
Adding special salt
If the special salt refill indicator lights
up, add special salt to the dispenser for
special salt just before the programme
starts. The amount of special salt re-
quired depends on the water hardness:
the higher the water hardness, the
greater the amount of special salt re-
quired.
ATTENTION!
● Detergent may damage the water
softening system.
● Only fill the dispenser of the water
softening system with special dish-
washer salt.
● Special salt can damage the tub due
to corrosion.
● To make sure that any special salt
that escapes is washed out of the
tub, add the special salt to the dis-
penser for special salt immediately
before the programme starts.
1. Unscrew the lid of the dispenser for
special salt and remove.
2. On initial start-up: Fill the dispenser
right up with water.
3. Note:Only use special salt for dish-
washers.
Do not use salt tablets.
Do not use table salt.
Add the special salt to the dispenser.
a
Funnel
Fill the dispenser right up with spe-
cial salt. The water in the dispenser is
displaced and forced out.
4. Place the lid back on the dispenser
and turn to close.

IKEA DISKAD Specifications

General

Brand	IKEA
Model	DISKAD
Category	Dishwasher
Language	English