IKEA DISKAD User Manual

54
FAULT CAUSE TROUBLESHOOTING
Excessive formation of
foam occurs.
Rinse aid has been
spilled.
● Remove the rinse aid with a
cloth.
Detergent or appliance
care product used
causes excessive foam-
ing.
● Change the brand of deter-
gent.
Information on display panel
FAULT CAUSE TROUBLESHOOTING
Special salt refill indic-
ator lights up.
Insufficient special salt. ● Add Special salt →Page28.
Sensor does not detect
special salt tablets.
● Do not use special salt tab-
lets.
Refill indicator for spe-
cial salt does not light
up.
Water softening sys-
tem is switched off.
● Setting water softening sys-
tem →Page28
Refill indicator for rinse
aid lights up.
Insufficient rinse aid. 1. Add Rinse aid →Page30.
2. Set the amount of rinse aid
to be dispensed.
Refill indicator for rinse
aid does not light up.
Rinse aid system is
switched off.
● Set the amount of rinse aid
to be dispensed.
→"Setting the amount of rinse
aid", Page30
→"Setting the amount of rinse
aid", Page30
Malfunctions
FAULT CAUSE TROUBLESHOOTING
Water is left in the ap-
pliance at the end of
the programme.
Filter system or area
under the filters is
blocked.
1. Clean the Filters →Page42.
2. Clean the Wastewater pump
→Page57.
Programme has not
yet ended.
● Wait until the programme
ends or cancel the pro-
gramme with reset.
● →"Terminate programme",
Page37

IKEA DISKAD Specifications

General

Brand	IKEA
Model	DISKAD
Category	Dishwasher
Language	English