5.11 Program eFuse Region of PSoC™ 6 MCU
1. Connect the device to the host computer and select it in the Probe/Kit drop-down.
2. Select the programming file as described in the Load Programming File section. The programming file
should contain valid eFuse data region (at address 0x90700000).
3. Select the Program Security Data check box under Program Settings.
4. Connect to the device (see Connect Device).
5. Click the Program button.
CYP programs the device and displays various messages in the Log. Then, a message in the Status Bar indicates
that the device was programmed successfully or that an error occurred.
If some eFuse bits have been already programmed before, a warning message "The efuse bit at address xx has
been already blown" appears in Log.
To Next Page
Loading...
Need help?
General
