Programming Manual
24 Initialising the configuration/programming from panel
Press on the first line to add a new
device.
Note: To change an existing device: press keys
and
to scroll the list or type in the device number
and press to view the parameters.
Check “yyy” which represents the
address that the system has assigned to
the device.
Press keys and to change the
device type.
Press
to confirm and access the
parameter settings.
Press and to view the device
parameters.
7.5.3 Deleting a device from the Loop
FROM PANEL
<any key>, 8 Programming, <code>, 1 Configuration, 2 Modify
Configuration, 2 Manual Configuration, 1 Loop,
x Loop, 2 Remove Point,
or
<any key>,
8 <code
> 1 2 2 1 x 1
Eliminating a loop device at the control panel:
Press keys and on the first line to
view the devices.
Press to delete the device and step
back to the previous menu.
Press ESC to quit the operation without
eliminating the device.
7.5.4 Enrolling/Deleting Repeaters
FROM PANEL
<any key>, 8 Programming, <code>, 1 Configuration, 2 Modify
Configuration, 2 Manual Configuration, 2 Repeater,
or
<any key>
,
8 <code> 1
2 2 2
Note: The description will appear only when the Repeater is properly enrolled in the configuration.
Press keys and to navigate through
the loops.
Press keys and to enroll/delete a
Repeater
000 New Device Loop n. x
001 <Dev. Type> <Dev. Description>
002 <Dev. Type> <Dev. Description>
003 <Dev. Type> <Dev. Description>
Point x/yyy
Type : _tt <Dev. Type>
= Select type Enter = Confirm
Point x/yyy <Dev. Description>
Type : ttt <Dev. Type>
Activation Type : <Activation>
Pre-alarm : YN
Point x/yyy <Point Description>
Type : ttt <Type Description >
Device will be deleted .....
CONTINUE? Enter=YES Esc=NO
Repeater n
in Configuration : YN
<Repeater Description>
To Next Page
Loading...
Need help?
General
