Programming Manual
40 Programming the system
The following codes are already active at default:
Refer to the Installation Manual - paragraph 2.5 Operator authorization—access levels.
FROM PANEL
<any key>, 8 Programming, <code>, 7 Access Codes, xxx Code,
or
<any key>,
8 <code> 7 xxx
Press keys and to view the other
codes.
Press key
to go to the successive field.
Note: PINs may have 4 or 5 digits.
13.4 Setting up holiday periods
FROM COMPUTER
Go SmartLoop System, System Programming, Holidays
This option will allow you to set specific periods which determine exceptions with regard timer
programming, for example, holidays, bank holidays, etc.
13.4.1 Parameters
FROM PANEL
<any key>, 8 Programming, <code>, 4 TIMER Programming,
2 Holiday list,
or
<any key>,
8 <code> 4 2
Press keys and on the first line to
view other holidays.
Press keys and to scroll the
parameters list.
Press keys and on the other lines
to change the values.
Level 1 Building occupants - -
00001 User
00002 Authorized User
00003 Maintenance
00004 Installer
Day of the
week
Day of the week for weekly arrangements. Valid only if Duration = 1
Day of the
month
Month
Year
Date of the holiday or start date of the holiday period. If you do not wish to specify the day,
month or year, set “--”. For example, to set the 3rd of every month of every year enter:
day=3, month = “--”, year = “--”. If you wish to create the setting using the day of the
week (e.g. Sunday), the day, month and year fields must be left as “--”.
Duration Duration expressed in days of the holiday period (1 at default).
001 <Code Description>
Access level : <level>
< PIN >
Holiday Num. 01
DAY : dd
MONTH : mm
YEAR : yy
To Next Page
Loading...
Need help?
General
