Programming Manual
Introduction 7
Chapter 1
Introduction
This Manual describes the essential configuration phases of a fire alarm system and the programming
process of the control panel.
The instructions herein are pertinent mainly to the SmartLoop system.
Refer to the User's Manual for the descriptions of the visual signals provided by the control panel LEDs
and display.
Note: The control panels described in this manual have been designed and developed to the highest
standards of quality, reliability and performance. All product components are capable to
application requirements and are able to operate in compliance with the related technical
specifications when the temperature external to their casing complies with Category 3k5 of IEC
721-3-3.
1.1 In order to validate the IMQ-SISTEMI DI SICUREZZA certification, and
in compliance with EN54-2 regulations:
1. All the manual alarm buttons and fire detectors employed in the system must be associated with
fire detection and alarm functions.
2. The functions associated with the programmable LEDs on the control panel frontplate, and on
SmartLetUSee/LCD and SmartLetUSee/LED Repeaters must be set up in accordance with the
colour of the LEDs, as follows:
•RED: FIRE ALARM STATUS
•YELLOW: FAULT, TEST and DISABLED STATUS
Note: The GAS control function is not EN54-2 compliant, as this feature is not mentioned in the
aforesaid standard.
To Next Page
Loading...
Need help?
General
