To Next Page

To Previous Page

- 48 -

4.2 Description of Function Code Viewing and

Modification Methods

The operation panel of the IS300 servo driver adopts three-level menu

structure to carry out operations such as parameter setting.

The three-level menu includes function parameter set (level 1

menu)→Function code (level 2 menu)→Function code setup value (level 3

menu). Refer to Fig.4-2 for the operation procedure.

Parameter Set Modification

Function Code Modification

First-level Menu

Second-level Menu

Third-level Menu

Fig.4-2 Operation Procedure of Three-level Menu

Note: When operating on level 3 menu, press PRG key or ENTER key to return

to level 2 menu. The difference between PRG key and ENTER key is

described as follows: Pressing ENTER KEY will save the setup parameter and

return to the level 2 menu and then automatically shift to the next function code,

while pressing PRG key will directly return to level 2 menu without saving the

parameter, and it will return to the current function code.

Example: Modify the function code F3-02 from 10.00Hz to 15.00Hz. (The

bold-type work indicates the flashing bit.)

Fig.4-3 Example of parameter editing operation

In level 3 menu, if the parameter has no flashing bit, it indicates that the

function code cannot be modified. The possible reasons include:

1) The function code is an unchangeable parameter, such as actual

detection parameter, running record parameter, etc.

2) The function code cannot be modified in running status. It can be

modified only after the unit is stopped.

Inovance IS300 Series User Manual

Other manuals for Inovance IS300 Series