Intel Desktop Board DP55KG Product Guide
44
NOTE
For best memory performance, install memory in the blue DIMM sockets first.
To install a DIMM, follow these steps:
1. Observe the precautions in "Before You Begin" on page 31.
2. Turn off all peripheral devices connected to the
computer. Turn off the computer
and disconnect the AC power cord.
3. Remove the computer’s cover and locate the DIMM sockets (see Figure 22).
4. If
a full length PCI Express graphics card is installed in the PCI Express x16
connector, remove the card (see Removing a PCI Express x16 Grap
hics Card on
page 47) to gain access to the DIMM sockets.
Figure 22. Installing a DIMM
5. Make sure the clips at either end of the DIMM socket(s) are pushed outward to the
open position.
6. Holding the DIMM by the edges, remove it from its anti-static package.
7. Position the DIMM above the socket. Align the small notch at the bottom edge of
the DIMM with the keys in the socket (see inset in Figure 22).
8. In
sert the bottom edge of the DIMM into the socket.
9. When the DIMM is inserted, push down on the top edge of the DIMM until the
retaining clips snap into place. Make sure the clips are firmly in place.
To Next Page
Loading...
Need help?
General
