Intel® Server Board SE7520JR2 Design and Environmental Specifications
Revision 1.0
C78844-002
209
8.2.11 Soft Starting
The power supply shall contain control circuit that provides monotonic soft start for its outputs
without overstress of the AC line or any power supply components at any specified AC line or
load conditions. There is no requirement for rise time on the 5V Standby but the turn on/off shall
be monotonic.
8.2.12 Zero Load Stability Requirements
When the power subsystem operates in a no load condition, it does not need to meet the output
regulation specification, but it must operate without any tripping of over-voltage or other fault
circuitry. When the power subsystem is subsequently loaded, it must begin to regulate and
source current without fault. Each output voltage may not be internally diode isolated. At the
same time failure in the primary side of one power supply doesn’t cause the other to shut down.
8.2.13 Timing Requirements
These are the timing requirements for the power supply operation. The output voltages must
rise from 10% to within regulation limits (T
vout_rise
) within 5 to 70ms, except for 5VSB - it is
allowed to rise from 1.0 to 70ms. The +3.3V, +5V and +12V output voltages should start to rise
approximately at the same time. All outputs must rise monotonically. The +5V output needs
to be greater than the +3.3V output during any point of the voltage rise. The +5V output must
never be greater than the +3.3V output by more than 2.25V. Each output voltage shall reach
regulation within 50ms (T
vout_on
) of each other during turn on of the power supply. Each output
voltage shall fall out of regulation within 400msec (T
vout_off
) of each other during turn off. The
following figures show the timing requirements for the power supply being turned on and off via
the AC input, with PSON held low and the PSON signal, with the AC input applied.
Table 122: Output Voltage Timing
Item Description Minimum Maximum Units
T
vout_rise
Output voltage rise time from each main output.
5.0 * 70 *
msec
T
vout_on
All main outputs must be within regulation of each
other within this time.
50
msec
T
vout_off
All main outputs must leave regulation within this
time.
400
msec
Note:
The 5VSB output voltage rise time shall be from 1.0ms to 25.0ms
To Next Page
Loading...
Need help?
General
