To Next Page

To Previous Page

Power Supply Function

• If there is a waveform parameter related to setting the voltage value,

when the upper limit of the voltage setting defined in the regulation

exceeds the rated voltage of the instrument, the rated voltage of the

instrument is set as the upper limit. Otherwise, the output wave-

form may be distorted.

• Some voltage level models may not have certain automotive wave-

forms. For example, 80V voltage level models do not support LV123

high-voltage automotive waveforms.

Road-

Vehicles

Vehicle waveform function menu

DIN40839

Evaluation of automotive starting

waveform

ISO16750-2

Simulate the waveform to verify the

anti-interference performance of the au-

tomotive electronics’ products.

ISO21848 42V Road vehicles — Electrical and

electronic equipment for a supply volt-

age of 42 V — Electrical loads

SAEJ1113-11 SAEJ1113-11 Waveform protocol

LV123 LV123 Waveform protocol

LV124 LV124 Waveform protocol

LV148 LV148 Waveform protocol

ISO21780 ISO21780 Waveform protocol

Recall the Vehicle Waveform

Select any of the above five kinds of vehicle waveforms, after completing the

waveform parameter setting (see the subsequent introduction for each parame-

ter), the system will automatically enter the waveform recalling mode and wait

for the triggering operation. At this time, the VFD screen is displayed as the

main interface of the system, and the corresponding waveform name is dis-

played in the lower right corner.

ITech IT6000C Series User Manual

Questions and Answers: