To Next Page

To Previous Page

Power Supply Function

The trigger method of the battery test is consistent with the trigger method

of the List function, that is, the List trigger source is also effective for the

Battery function.

If you want to stop running during the battery test, you can do the following:

Press the composite keys [Shift]+[I-set] (Function) on the front panel to enter

the function menu.

At this point, the interface will prompt whether to stop the running of the Func-

tion, you can press the Left/Right key to select Stop, then the running will be

stopped, and the Function menu item will be displayed, you can re-enter the

Function menu for editing; if Reset is selected, it means to stop the present run-

ning and return to the main interface to wait for the next trigger operation; if

Pause is selected, it means that the present running is suspended, and you can

continue to run by selecting Resume.

4.6.3 Built-in Waveform Function

The IT6000C series power supply supports built-in waveforms for user to exe-

cute the test directly. The protocols/standards involved in the built-in waveforms

include the following:

• DIN40839

• ISO16750-2

• ISO21848

• SAEJ1113–11

• LV123

• LV124

• LV148

• ISO21780

The following is a general overview of this function menu, and the detailed pa-

rameters of the waveform corresponding to each protocol/standard can be

found in the corresponding chapter.

ITech IT6000C Series User Manual

Questions and Answers: