To Next Page

To Previous Page

Power Supply Function

7. Select the USB and press [Enter].

At this point, the system will automatically read all the List files in the root

directory of the USB flash drive. The interface is displayed as follows:

XXX.csv

Not-Load Load YY/ZZ

XXX indicates the name of the List file; YY indicates the serial number of

the current List file; ZZ indicates the total number of the List file.

8. Press the Up/Down key to select the file.

9. Press the Left/Right key to select Load, press [Enter] to complete the

import, and wait for the trigger to run this file.

10.Turn on the [On/Off].

11. Based on the selected trigger method, perform the trigger operation.

• Programming via SCPI instructions

For detailed instructions and parameter introduction, please refer to the in-

structions of "ARB Subsystem" in the Programming Guide.

• Realized by the software IT9000 on PC

For detailed function usage, please refer to IT9000–PV6000 User Manual.

4.6.2 Battery Charging/Discharging Test Function

The IT6000C series power supply provides the battery charging/discharging test

function based on its unique bipolar power supply properties. Suitable for charg-

ing/discharging tests on all types of portable batteries.

Before performing the battery test, you need to connect the

Sense cables to both ends of the battery. If the Sense cables are

not connected, the instrument cannot detect the Sense voltage

and prompt “Wait Power Link”, which will prevent the battery test

from continuing.

BATTERY

Battery charging/discharging test function

Run

Indicates that the battery test mode is entered and

waits to trigger the running of the currently edited bat-

tery test file.

Edit

Edit the battery charging/discharging test file.

ITech IT6012C-800-50 User Manual

Questions and Answers: