To Next Page

To Previous Page

List Function

Configure the List parameters under three-phase mode

List parameter configuration under the three-phase mode differs from that

under the single-phase mode. Other operating steps remain the same. List

parameter configuration interface under the three-phase mode is shown in the

figure below. The user can set a series of parameters such as waveform and

frequency of each step in the List interface. Press soft key [Insert] and the

system defaults to insert this single step under the three-phase balance mode.

The three-phase parameters remain consistent.

To set parameters of each phase, click [More] to appear a detailed interface of

List single-step parameter configuration under the three-phase mode. The user

can complete all configurations of the three-phase parameters, as shown in the

figure below. After configuring, go back to the List interface. Parameters with

inconsistent three-phase are marked with a “*” at front, as shown in the red box

above. The list only displays A-phase parameters.

ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com

ITech IT7622 User Manual

Other manuals for ITech IT7622