ITech IT8811 Programming Guide

Source Subsystem
Copyright © ITECH Electronic Co., Ltd. 53
[SOURce:]RESistance:HIGH
[SOURce:]RESistance:LOW
This command sets the high and low level of the voltage when in constant
resistance mode.
Command Syntax [SOURce:]RESistance:HIGH <NRf+>
[SOURce:]RESistance:LOW <NRf+>
Parameters MINimum through MAX | MINimum | MAXimum |
DEFault
Unit V (volts)
*RST Value MAXimum
Examples RES:HIGH 5
Query Syntax [SOURce:]RESistance:HIGH?
[MINimum|MAXimum|DEFault ]
[SOURce:]RESistance:LOW?
[MINimum|MAXimum|DEFault ]
Returned Parameters <NR3>
[SOURce:]RESistance:VDRop
This command sets the constant resistance mode of the loads and the LED
cut-off voltage value when LED test function is ON.
Command Syntax [SOURce:] RESistance:VDRop <NRf+>
Parameters 0 through MAX | MINimum | MAXimum | DEFault
Unit V (volts)
*RST Value MINimum
Examples RES:VDR 5
Query Syntax [SOURce:] RESistance:VDRop? [ MINimum |
MAXimum | DEFault ]
Returned Parameters <NR3>
Related Commands VOLT:VDR
[SOURce:]RESistance:LATCh[:STATe]
This command selects to enable or disable the LED test selection in constant
resistance mode.
Command Syntax [SOURce:]VOLTage:LATCh[:STATe] <b>
Parameters 0 | 1 | ON | OFF
*RST Value ON
Examples VOLT:LATC 1
Query Syntax [SOURce:]VOLTage:LED[:STATe]?
Returned Parameters 0 | 1
Related Commands VOLT:ON
[SOURce:]POWer
This command sets the power of the load when operating in constant power
mode.
Command Syntax [SOURce:]POWer[:LEVel][:IMMediate] <NRf+>

ITech IT8811 Specifications

General

Brand	ITech
Model	IT8811
Category	Test Equipment
Language	English