List Commands
Copyright © ITECH Electronic Co., Ltd. 58
Related Commands LIST:RANG
[SOURce:]LIST:SLEW
This command sets the slew rate for each step. This command programs both
positive and negative going slew rates. MAXimum sets the slew to its fastest
possible rate. MINimum sets the slew to its slowest rate. LIST:SLEW? returns
the number of points programmed.
Command Syntax [SOURce:]LIST:SLEW[:BOTH] <NR1> ,<NRf>
Parameters 1 to steps, MIN to MAX
Unit NONE, NONE
Examples LIST::SLEW1, 1.5 LIST:SLEW 2, MAX
Query Syntax [SOURce:]LIST:SLEW[:BOTH]? <NR1>
Returned Parameters <NR3>
Related Commands CURR:SLEW VOLT:SLEW RES:SLEW
[SOURce:]LIST:WIDth
This command sets the time width of each step of a LIST. Each value
represents the time in seconds that the input will remain at the particular list
step point before completing the step. If times exceed 16383S, the input
remains at the present level until a trigger sequences the next point in the list.
Else At the end of the dwell time, the input automatically changes to the next
point in the list.
Command Syntax [SOURce:]LIST:WIDth <NR1>, <NRf>
Parameters 1 to steps, 20uS to max
Unit NONE, s (seconds)
Examples LIST:WID 1, 0.02 LIST:WID 2, 0.5
Query Syntax [SOURce:]LIST:WIDth? <NR1>
Returned Parameters <NR3>
[SOURce:]LIST:SAV
This command stores the present list file of the electronic load to a specified
location in memory. Up to 5 files can be stored. file in saved in locations 1-5 are
volatile, the data are nonvolatile, the data will be saved when power is
removed.
Command Syntax [SOURce:]LIST:SAV <NR1>
Parameters 1 to 7
Example LIST:SAV 3
Related Commands [SOURce:]LIST:RCL
[SOURce:]LIST:RCL
This command restores a list file that was previously stored in memory with a
LIST:SAV command to the specified location.
Command Syntax [SOURce:]LIST:RCL <NR1>
Parameters 1 to 7
Example LIST:RCL 3
Related Commands [SOURce:]LIST:SAV
To Next Page
Loading...
Need help?
General
