12 SPECIFICATIONS
en-89
12.6 NOISE ___________________________________________________________________
When the machine was tested for sound pressure (Operator Ear).
The Machinery Safety Directive 2006/42/EC
And
Exposure Of Workers To The Risks Arising From Physical Agents (Noise) Directive 2003/10/EC
By compliance to:
The Lawnmower Standard BS EN ISO 5395:2013
And
Sound Pressure Standard EN ISO 3746: 2010
ROPS machine: Measured Sound Pressure TBD dB(A) ± 0.6 LWA
When the machine was tested for sound power (Noise in the Environment).
The Machinery Safety Directive 2006/42/EC
And
Noise Emission In The Environment By Equipment For Use Outdoors
Directive 2000/14/EC
By compliance to:
Sound Power Standard EN ISO 3744:2010
Measured Sound Power 102 dB(A) ± 0.6 LWA
12.7 SLOPES _________________________________________________________________
DO NOT USE ON SLOPES GREATER THAN 21°. The slope was calculated using static stability measurements
according to the requirements of BS EN ISO 5395:2013
12.8 CUTTING PERFORMANCE __________________________________________________
208 cm (82 in.) width of cut:
1.82 hectares/hr. At 9.66 kph.
4.5 acres / at 6 mph
(10% allowance is included for normal overlaps and turning at the end of each cut).
12.9 CUTTER DECK SPECIFICATION _____________________________________________
Product
(2 LH Reels and 3 RH Reels
Required)
62298 (LH) / 62859 (RH) Reel Cutting Unit 62299 (LH) / 62860 (RH) Reel Cutting Unit
Number of Reel Blades 8 11
Reel Cutting Width 45.7 cm (18 inch)
Height of Cut 7.6 mm - 18 mm (0.30 inch - 0.70 inch)
Height of Cut Adjustment Lift or lower front roller with adjustment knobs on the ends of reel.
Transmission By Hydraulic motor to drive side of reel.
To Next Page
Loading...
Need help?
General
