29
J-300
1. Press and hold then;
2. Press and hold the
1
at the same
time for 2 seconds. You will see the
temperature change to 105°F (40.5°C)
on the LCD display. Press to raise
the temperature to 106°F (41°C) To
lower the temperature, press .
3. When the overtemp has been activated, the asterisk after the last
digit will appear as an indicator for being in the overtemp mode,
Figure 10.3a.
Note: Once the temperature goes below 104°F (40°C) and you would
like to raise the temperature to 106°F (41°C) again, you will have to
repeat the steps.
10.4 Activate Jet Pumps
The JETS 1 (
1
) button activates jets pump 1. The rst press
turns jets pump 1 on; the second press turns jets pump 1 off.
The JETS 2 (
2
) button activates jets pump 2 (if equipped).
The rst press turns jets pump 2 on; the second press turns
jets pump 2 off. When manually activated, either pump will automatically
turn off after 20 minutes.
10.5 Light On/Off Button
Pressing this button activates the waterfall light, footwell light,
lighted cup holders, and backlit pillows lights in unison as
follows: high - medium - low - off.
Note: Lights automatically turn off after 2 hours.
10.6 Light Mode Button
This button offers 4 light modes for your enjoyment. Press this
button to select your favorite lighting effect as follows:
1st press high speed blend mode
2nd press low speed blend mode
3rd press freezes low speed blend mode
4th press solid Blue color
5th press solid Violet color
6th press solid Red color
7th press solid Amber color
8th press solid Green color
9th press solid Aqua color
10th press solid Near White color
11th press goes back to high speed blend mode
2
1
Figure 10.3a
1
2
To Next Page
Loading...
Need help?
General
