32
J-300
11.0 Menu Features and Programming Instructions
Your spa is equipped with menus that allow you to program additional
features. By continually pressing the Menu ( ) button you will cycle
through the menus as follows (Figure 1):
Current temperature (Main Menu)
Primary Filtration (page 32)
Secondary Filtration (page 33)
Heat (page 34)
Filter Change (page 35)
UV (page 35)
H2O (page 36)
Time (page 36)
Date (page 37)
Temp (page 37)
Language (page 37)
Lock (page 38)
WiFi (page 38)
S\N (page 27)
11.1 Primary Filtration Menu
During the primary ltration cycle, the circulation pump and CLEARRAY
are activated. The spa is programmed with a default setting starting at
12:00 AM and lasting for 8 hours, but this can be changed. This cycle
allows the circulation pump to run for a preset amount of time per day, in
addition to the normal operation.
Note: Any time the circulation pump runs outside of a program cycle,
e.g. for heating, that run time will be deducted from the next primary lter
cycle. For example, the primary lter cycle is set to 8 hours every 24
hours but the circulation pump comes on for 2 hours to heat the water
after the cycle has nished. The next primary lter cycle will only be for 6
hours not 8 hours.
Figure 1
To Next Page
Loading...
Need help?
General
