Jacuzzi Lodge L User Manual

29
XClearray™ operates automatically and is dependent on pump
activation (or the ltration pump, where present) during the l-
tering cycle, it remains o when the hydromassage, blower or even
just the spotlight are on (as it is presumed that there is somebody
in the tub); Clearray™ (where a ltering cycle is active) begins oper-
ating once again 40 minutes subsequent to switching o the afore-
mentioned functions.
Rapid Filtering (“Boost”)
( “hydro” and “hydro+blower” versions only)
This is recommended after intensive use of the hot tub and/or is as-
sociated with chemical treatment of the water, to favour the disso-
lution of substances used for disinfection.
XTo activate this function, press and hold down the “Pump”
key for 5 seconds. The display will show the message boo.
XThe operation lasts 45 minutes (this time period cannot be
modied) during which the pump is activated together with
Clearray™ (where present).
NOTES:
- If the heater is on, it will continue to run normally, unless the sys-
tem is congured for limitation of electrical consumption.
- the ltration pump is activated in “blower” models.
XThe function stops:
- when the aforementioned time expires
- when another function is activated.
- pressing the key Pump” again
.
NOTE: if you need to activate the anti-freeze protection during rap-
id ltering, rapid ltering will be stopped to allow the anti-freeze
protection to be started.
Hydromassage activation
XThis function is activated by pressing the “Pump” key or,
in some models, with the key :
In “hydro with heater” and “hydro +blower with heater”
models, the rst time the key is pressed starts the pump at a
low speed (if not already on to heat the water or for ltration),
the second time starts the high speed, and the third time
turns it o.
In “hydro with heat exchanger” models, the hydromassage
pump is turned on by the key
whereas the key “ turns
the ltering pump on and o (if not already on to heat the wa-
ter or for ltering).
In “hydro+blower with heat exchanger” models, the oper-
ation is as follows:
- the rst time the key is pressed turns on the ltering pump
(if not already on to heat the water or for ltering);
- the second press turns on the hydro pump;
- the third time the key is pressed turns o the ltering pump
(not available while heating the water or ltering);
- the fourth press turns o the hydro pump;
In “blower” models, the key turns the ltering pump on
and o (if not already on to heat the water or for ltering).
NOTES
The function turns o automatically after 20 minutes (if not turned
o by the user).
Blower activation (where present)
XPress the key “Blower” to activate the air compressor
(the LED comes on).
XThe blower can be activated either in conjunction with, or
separately from, the pump (when the system turns on, the blow-
er is always o).
XThe blower stays on for 20 minutes. It can be shut o before that
by pressing the key again.
XIf you want to use the blowers for aroma therapy (if installed),
insert the perfume cartridge in the compartment located under
the cover; once this cartridge is nished, it can be replaced with
a new one (cartridges are available from authorised Jacuzzi® deal-
ers and service centres).
CAUTION: Replace used cartridges when the blower is o.
Underwater spotlight
XPress the key “Light” to activate the spotlight located on
the wall of the tub (the LED comes on).
XThe spotlight will stay on for two hours, but it can be turned
o before that by pressing the key again. Refer to the user’s man-
ual for the operation of the various sequences of colours.
Temporary shutdown of system (stand-by)
This function lets you suspend operation of all system devices for a
period of 60 minutes (this value cannot be changed) so that you
can perform routine maintenance without having to disconnect
the power supply.
CAUTION

If you need to access the electronic parts, parts that are
normally powered, or the rotating parts of the pumps,
you must disconnect the electric power by turning o
the all-pole circuit breaker.
XTo activate the function, press and hold the “Light”
key
for about 8 seconds: the display will show the message “Sby” fol-

Jacuzzi Lodge L Specifications

General

Brand	Jacuzzi
Model	Lodge L
Category	Hot Tub
Language	English