5 - 1
Removal
1. Slacken the check valve to bleed out grease.
!!
WARNING
When opening the check valve always stand to one side
and loosen a little at a time until grease starts to come
out. If you over-loosen too much grease could spurt out
or the valve cover fly out and cause serious injury.
8-3-4-5
2. Disconnect the track link (see Track Motor/Reduction
Gearbox, Removal and Replacement, Section F).
Move the idler wheel and recoil assembly to the end of
the undercarriage using a bar.
!!
WARNING
Stand clear and to one side of the track while you
remove the master pin. When the master pin is removed
the track could fall forward and injure you.
TRACK 1-1
3. Fasten a sling around the idler wheel and recoil
assembly and remove it from the undercarriage.
4. Remove the bolts and remove the idler wheel from the
recoil unit.
Section J
Track and Running Gear
9803/6400
Section J
5 - 1
Issue 2*
Grease Cylinder
*
To Next Page
Loading...
Need help?
General
