Operation
Seat Controls
29 29
9811/5700-7
Seat Controls
Introduction
T2-007_3
!MWARNING
Seat
Position the seat so that you can comfortably reach
the machine controls. Do not adjust the seat while the
machine is moving. You could have an accident if you
operate the machine with the seat in the wrong
position.
13-1-1-9_1
The operator's seat can be adjusted for your comfort. A
correctly adjusted seat will reduce operator fatigue.
Position the seat so that you can comfortably reach the
machine controls. For driving the machine, adjust the seat
so that you can depress the pedals fully with your back
against the seat back.
Basic Seat
P5-2026
1 Fore/Aft
Lift bar 1 and slide the seat to the position you want.
Release the lever. Make sure the seat is locked in
position.
2 Backrest Angle
Press your back firmly against the backrest. Press
down either of the two levers 2 and put the backrest
at the angle you want. Release lever 2.
3 Height
To raise or lower the front of the seat, pull bar 3 up and
raise or lower the seat cushion. Release the bar at the
height you want. (There are three settings.)
To raise or lower the rear of the seat, push the seat
cushion backwards, then set it into one of the three
notches provided.
4 Weight
Sit in the seat and check the position of indicator 4. It
should be level with the front edge of the side frame
as shown in 4A.
If the indicator is behind the frame as shown in 4B,
turn the handle 5 so that + is uppermost. If the
indicator is in front of the frame as in 4C, turn handle
5 so that - is uppermost. Stay in the seat. Pump
handle 5 until the indicator is level as in 4A.
Fig 14.
To Next Page
Loading...
Need help?
General
