Operation
Seat Belt
31 31
9811/5700-7
Seat Belt
Inertia Reel Seat Belt
T2-001_2
!MWARNING
If you do not wear your seat belt you could be thrown
about inside the machine, or thrown out of the
machine and crushed. You must wear a seat belt when
using the machine. Fasten the seat belt before starting
the engine.
8-2-9-2_1
!MWARNING
When a seat belt is fitted to your machine replace it
with a new one if it is damaged, if the fabric is worn, or
if the machine has been in an accident. Fit a new seat
belt every three years.
2-3-1-7_1
Fasten the Seat Belt
1 Sit correctly in the seat. Pull the belt from its reel
holder in one continuous movement.
2 Push the male fitting A into the buckle B until it
latches into position. Make sure the seat belt is not
twisted and that it is over your hips not your stomach.
C006840-1
Fig 17.
Note: If the belt 'locks' before the male fitting A has been
engaged, allow the belt to fully retract in its reel holder and
then try again. The inertia mechanism may lock if you pull
the belt too sharply or if the machine is parked on an
incline. In such cases, ease the belt gently from its reel
holder.
Check the Seat Belt is Operating Correctly
1 Sit correctly in the seat and fasten the seat belt as
described.
2 Hold the middle of the seat belt as shown at D and
tug. The seat belt should 'lock'.
!MWARNING
If the seat belt does not 'lock' when you check if the
seat belt is operating correctly, do not drive the
machine. Get the seat belt repaired or replaced
immediately.
2-2-2-1
C006850-1
Fig 18.
Release the Seat Belt
!MWARNING
Release the seat belt only after switching off the
engine.
2-2-1-10
1 Press button C and pull the male fitting A from the
buckle.
2 Let the seat belt retract into its reel holder.
To Next Page
Loading...
Need help?
General
