Routine Maintenance
Service Requirements
88 88
9811/5700-7
occurs first). You should notify your Distributor in advance
to allow the necessary arrangements to be made.
Fit for Purpose Tests for Lifting
Equipment
T3-097
All lifting equipment (for example forks, lifting hooks and
shackles) need regular inspection and testing by a
competent person to ensure they are fit for purpose.
This may be needed every six months or at least annually
in some countries to meet and comply with legislation and
for insurance purposes.
Check with your local JCB distributor for further advice.
Obtaining Replacement Parts
T3-096
If you use non-genuine JCB parts or consumables, then
you can compromise the health and safety of the operator
and cause machine failure
A Parts Book for your machine is available from your JCB
Distributor. The Parts Book will help you identify parts and
order them from your JCB distributor.
Your dealer will need to know the exact model, build and
serial number of your machine. See Identifying Your
Machine (Introduction section).
The data plate also shows the serial numbers of the
engine, transmission and axle(s), where applicable. But
remember if any of these units have been changed, the
serial number on the data plate may be wrong. Check on
the unit itself.
To Next Page
Loading...
Need help?
General
