0.5~1
3~7
Applique
- Turn stitch length dial to the
desired length.
- Turn zig-zag width dial to
small width.
- Cut out the applique design
and baste it to the fabric.
- Sew slowly around the edge
of the design.
- Trim excess material outside
the stitching. Make sure not to
cut any stitches.
- Remove the basting thread.
- Tie top and bottom thread
under the applique to avoid
unraveling.
1~4
0
Darning
- Turn stitch length dial to the
desired length.
- Turn stitch selector to straight
stitch, center needle position.
- Position the fabric to be
darned under the presser foot
together with the under laying
fabric to be used.
- Lower the presser foot and
alternately sew forward or
reverse using the lever.
- Repeat this motion until the
area to be darned is filled with
rows of stitching.
For reverse sewing instructions,
see page 12.
To Next Page
Loading...
Need help?
General
