5
1
2
3
1
4
1
2
3
220
4-4. Adjusting the height of the knee lifter
1) The standard height of the presser foot lifted using
the knee lifter is 10 mm.
2) You can adjust the presser foot lift using knee lifter
adjust screw 1.
Do not operate the sewing machine
in the state that presser foot 3 is
lifted by 10 mm or more since needle
bar 2 and presser foot 3, or wiper
4 and presser foot 3 come in
contact with each other.
4-2. Removing the needle bar stopper
Remove needle bar stopper 1 for transportation.
Keep the needle bar stopper which has
been removed, and install this needle
bar stopper when transporting the
sewing machine.The needle bar
stopper may be cut when it is strongly
drawn out. Slightly move the needle bar
to the right or left and slowly draw out
the needle bar stopper.
4-3. Attaching the knee-lifter
Insert knee-lifter into attaching hole 2 and tighten it
with bolt 3.
* Adjust the position of knee lifter pad 1 to a
convenient place. For the reference dimension, the
position is 180 mm from the bottom face of table.
Cau tion
Cau tion
To Next Page
Loading...
Need help?
General
