ii
FOR SAFE OPERATION
1. To avoid personal injury, never operate the machine with any of the finger guard or
safety devices removed.
2. To prevent possible personal injuries caused by being caught in the machine, keep
your fingers, head and clothes away from the handwheel while the machine is in
operation. In addition, place nothing around it.
3. To avoid personal injury, never put your hand under the needle when you turn “ON”
the power switch or operate the machine.
4. To avoid personal injury, never put your fingers into the thread take-up cover while the
machine is in operation.
5. The hook rotates at a high speed while the machine is in operation. To prevent possible
injury to hands, be sure to keep your hands away from the vicinity of the hook during
operation. In addition, be sure to turn OFF the power to the machine when replacing
the bobbin.
6. To avoid possible personal injuries, be careful not to allow your fingers in the machine
when tilting/raising the machine head.
7. To avoid possible accidents because of abrupt start of the machine, turn OFF the
power to the machine when tilting the machine head or performing replacement of
parts, adjustment of the machine, etc.
8. The motor does not produce noise while the machine is at rest. To avoid possible
accidents due to abrupt start of the machine, be sure to turn OFF the power to the
machine.
9. To avoid electrical shock hazards, never operate the sewing machine with the ground
wire for the power supply removed.
10. To prevent possible accidents because of electric shock or damaged electrical
component(s), turn OFF the power switch in prior to the connection/disconnection of
the power plug.
11. To prevent fires, periodically draw out the power plug from the plug socket and clean
the root of the pins and the space between pins.
12. Do not turn OFF the power switch while the machine is in operation.
13. Hold the upper side of the machine head with both hands and perform the work quietly
so as not to allow your fingers or the like to be caught in the machine when tilting the
machine head or returning it to the home position.
14. Be careful that any load is not applied to the operation panel section.
1. To avoid electrical shock hazards, neither open the cover of the electrical box nor
touch the components mounted inside the electrical box.
To Next Page
Loading...
Need help?
General
