– 16 –
[When using area 1510 or 2210]
When area 1510 or 2210 is used, connect the pneumatic components after having carried out
[Connec-
tion common to all areas]
.
Connector not
connected
Stop plug
8
!3
6) Install the retaining plugs supplied as accesso-
ries with the machine to solenoid valve asm.
8
.
7) Connect air tube
!33
of solenoid valve installing
plate A asm.
!1
solenoid valve asm.
8
.
Stop plug
8) Install air tubes coming from the machine head
to the joint of solenoid valve installing plate A
asm.
!1
as shown in the gure.
I
nstall cords (CN2, CN3, CNS) coming from the
control box to the solenoid valve.
!3
Air tube 2A
Air tube 1A
Air tube 2B
Air tube 1B
!1
CN3
CN2
CNS
When using the area 1510 or 2210 of the solid presser type as the right/left separated
pressers, perform the connection of [In case of using area 1306].
Separate type feeding frame is made to special order.
If a cable has a slack, x the cable on
the table by means of a stapler sup-
plied with the unit.
At this time, provide the cable with an
adequate play (allowance) to prevent
the related connector from being ap-
plied with an excessive load.
3-15. Installing the air hose (Pneumatic type only)
1
2
Close
Open
1) Connecting the air hose
Connect the air hose to the regulator.
2) Adjustment of air pressure
Open air cock
1
, pull up and turn air adjust-
ment knob
2
and adjust so that air pressure
indicates 0.35 to 0.4 MPa (Max. 0.55 MPa).
Then lower the knob and x it.
*
Close air cock
1
to expel air.
To Next Page
Loading...
Need help?
General
