− 13 −
Functions can be selected and specified by means of the four setting switches and light emitting diode
located inside the front cover of the SC-500.
(Caution) 1. Do not perform switch operations other than those described in the following explanations.
2. Be sure to re-turn the power switch ON after one second or more has passed. If the power
is turned ON immediately after turning it OFF, the sewing machine may not work normally.
In this case, turn ON the power again.
How to change over to the function setting modo
(1) Turn OFF the power to the unit.
(2) Pressing switch 4, turn ON the power to the unit.
(3) Indication 5, 6 will be shown on the display. (If
the indication fails to change, re-perform the
procedures 1) and 2).
1
2
34
5
6
4
4
1 Switch for entering specified value changed
and updating setting No. in DOWN direction
2 Switch for entering specified value changed
and updating setting No. in UP direction
Specified value
Specified No.
3 Down switch (DOWN)
4 Up switch (UP)
(3) Setting for functions of SC-500
To Next Page
Loading...
Need help?
General
