Juniper CTP2000 Series Hardware Guide

Figure 4: CTP2008 Platform Containing the PP332 Processor (DC Version, Rear View)
g015354
ETH1 USBConsolePower A input connector
COM2 COM3
PMC I/O 1PMC I/O 2
Not used Not used
Not used
ETH0
ESD
-48VDC
RTN
Fuse
RELATED DOCUMENTATION
CTP2024 Platform | 5
CTP2056 Platform | 7
CTP2024 Platform
The Juniper Networks CTP2024 Circuit to Packet platform can have up to three removable interface
modules and one removable processor module, and is available in both AC-powered and DC-powered
versions. It has a removable fan tray, and airflow is side-to-side. Figure 5 on page 5, Figure 6 on page 6,
and Figure 7 on page 7 show the CTP2024 chassis containing the PP332 processor (which requires an
RTM card for Ethernet and console port accesses). The new PP833 processor module does not require an
RTM card. All PP833 module access is located on the front panel with all CTP serial and T1/E1 ports. If
you are upgrading from the old PP310 or PP332 processor to the PP833 processor, the RTM card may
be left in the node. But, none of the interfaces (Ethernet or serial ports) on the RTM panel are functional.
Figure 5: CTP2024 Chassis Containing the PP332 Processor (AC and DC Version, Front View)
USB
Optional fiber PMC
Power supply screw Power supply extractor
Interface module, slot 0
Fan tray with fan alarm
Removable air filter
Interface module, slot 1
Interface module, slot 2
g015388
The front panel comprises the following components (see Figure 5 on page 5):
5

Juniper CTP2000 Series Specifications

General

Brand	Juniper
Model	CTP2000 Series
Category	Network Hardware
Language	English