•
Racks are installed and electrically grounded according to manufacturer instructions.
•
Equipment racks are anchored to the floor and, when possible, anchored to the ceiling as well.
•
Equipment rack installations comply with applicable local, state, and national codes.
RELATED DOCUMENTATION
CTP2000 Mechanical Requirements | 42
CTP2000 Rack Requirements | 42
CTP2000 Space Requirements | 43
Special Guidelines for Installing CTP2056 Chassis in a Rack | 91
CTP Cabling Recommendations
We suggest that you comply with the following recommendations:
•
Ensure that cable distance and rate limits meet IEEE-recommended maximum speeds and distances for
signaling purposes. For information about attenuation and power loss in optical fiber cables see:
•
ANSI T1.646a-1997 Telecommunications – Broadband ISDN - Physical Layer Specification for
User-Network Interfaces Including DS1/ATM (1997)
•
ANSI T1.646-1995 Telecommunications – Broadband ISDN - Physical Layer Specification for
User-Network Interfaces Including DS1/ATM (1995)
•
Ensure that power cables deliver sufficient power to the device.
•
Attach laser fiber connectors only to Class 1 laser devices in accordance with IEC 60825-1, Safety of
Laser Products - Part 1.
•
Route cables so that they do not restrict ventilation or airflow.
•
Route cables so that modules and field-replaceable units are easily accessible.
•
Route cables in a logical direction to prevent loss of connectivity to other equipment in the rack, associated
equipment in adjacent racks, or to the backbone network.
•
Consider using cable-management brackets to keep network cables untangled and orderly and to prevent
cables from hindering access to other slots.
For additional cable recommendations, consult the document GR-63–CORE: Network Equipment Building
System (NEBS) Requirements: Physical Protection, Issue 2, April 2002.
44
To Next Page
Loading...
Need help?
General
