The series of login prompts requires the following settings:
1. Default username (ctp) and password (ctp).
2. Password for the root user—The system verifies that the password meets the security
profile requirements. However, you can use a noncompliant password by reentering
it during the password confirmation prompt.
3. Supported protocol or protocols—(0) IPv4 only, (1) IPv6 only, or (2) IPv4 and IPv6.
Enter the appropriate number value.
4. Default interface—From the list of available devices, such as eth0 and eth1 (or more),
enter the one to be the default.
5. Hostname of the device.
6. IP address of the interface—Enter the IP address of the selected interface, or accept
the loopback address (127.0.0.1) by default.
7. Netmask of the IP address—Enter the netmask (such as 255.255.255.128), or accept
255.255.255.0 as the default.
8. Gateway IP address—Enter the IP address of the gateway, or accept the local address
(127.0.0.1) as the default
9. Maximum transmission unit (MTU)—Enter the MTU in bytes, or accept 1500 bytes as
the default.
10. Static routes added to the default interface, if any.
11. Date and time GMT (more precisely, UTC)—Enter these separately in digits for the
month, day, hour, and minutes in Coordinated Universal Time (UTC), or accept the
internal settings.
The device goes into startup mode.
For example:
...
*********** Setting up the root password ************
Changing root's password!
Changing password for user root.
New password:
Retype new password:
passwd: all authentication tokens updated successfully.
************** Setting up the network ***************
Configure supported protocols:
19Copyright © 2019, Juniper Networks, Inc.
Step 6: Power On
To Next Page
Loading...
Need help?
General
