To Next Page

To Previous Page

0) IPv4 Only

1) IPv6 Only

2) IPv4 and IPv6

Please select your option (rtn for 0):

There are 4 ethernet devices available for use. The default device

is the device through which the default gateway can be accessed.

Ctp circuits can run over any ethernet device, default or not.

A default device must be configured, other devices may be configured

and enabled, or disabled. Here is a list ot the available devices

and their descriptions:

eth0: 10/100/1000 Copper (front)

eth1: 10/100/1000 Copper (back)

eth2: 1000 Fiber (left)

eth3: 1000 Fiber (right)

What device would you like to make the IPV4 default device? (rtn for eth0): eth1

OK, eth1 (10/100/1000 Copper (back)) will be configured as IPV4 default device.

Please input the hostname (return for (none)): nova_54

===== Configuration for eth1 (default device):

Please input the ip (return for 127.0.0.1): 172.25.61.54

Please input the netmask (return for 255.255.255.0): 255.255.255.128

Please input the gateway (return for 127.0.0.1): 172.25.61.1

Please input the mtu in bytes (return for 1500):

Add route to interface eth1 [n]

======================================

=== OS Security level set to LOW ===

======================================

************** Setting up date/time *****************

Setting the date (GMT). Please input the year [2008-2020] (return for 2010):

Setting the date (GMT). Please input the month [1-12] (return for 01):

Setting the date (GMT). Please input the day [1-31] (return for 11):

Setting the date (GMT). Please input the hour [0-23] (return for 20):

Setting the date (GMT). Please input the minute [0-59] (return for 22):

INIT: Entering runlevel: 3

Entering non-interactive startup

...

During initial power-on, the components of the platform run boot code, go through a

series of self-diagnostic tests, and synchronize with each other.

When the tests are completed, use the LEDs on each module to determine the status of

the device. Observe the module LEDs on the front or rear components.

CTP2000 Series Platform Quick Start

Juniper CTP2000 Series User Manual

Other manuals for Juniper CTP2000 Series