Juniper J-Series Administration Guide

Using the Monitoring Tools
This section describes the monitoring tools in detail. It contains the following topics:
■ Monitoring System Properties on page 107
■ Monitoring the Chassis on page 111
■ Monitoring the Interfaces on page 113
■ Monitoring Routing Information on page 115
■ Monitoring Class-of-Service Performance on page 123
■ Monitoring MPLS Traffic Engineering Information on page 130
■ Monitoring Service Sets on page 135
■ Monitoring Firewalls on page 136
■ Monitoring IPSec Tunnels on page 140
■ Monitoring NAT Pools on page 142
■ Monitoring DHCP on page 143
■ Monitoring RPM Probes on page 145
■ Monitoring PPP on page 147
■ Monitoring PPPoE on page 148
■ Monitoring the TGM550 Media Gateway (VoIP) on page 151
Monitoring System Properties
The system properties include everything from the name and IP address of the
Services Router to the resource usage on the Routing Engine. To view these system
properties, select Monitor>System in the J-Web interface, or enter the following CLI
show commands:
■
show system uptime
■
show system users
■
show system storage
Table 48 on page 107 summarizes key output fields in system properties displays.
Table 48: Summary of Key System Properties Output Fields
Additional InformationValuesField
System Identification
Serial number for the J-series Services Router.Serial
Number
Export software is for use outside of the U.S. and
Canada.
Version of JUNOS software active on the Services
Router, including whether the software is for domestic
or export use.
JUNOS
Software
Version
Using the Monitoring Tools ■ 107
Chapter 7: Monitoring the Router and Routing Operations

Juniper J-Series Specifications

General

Brand	Juniper
Model	J-Series
Category	Network Router
Language	English