Juniper J-Series Administration Guide

DHCP is not supported on interfaces that are part of a virtual private network (VPN).
Before You Begin
Before you begin configuring the Services Router as a DHCP server, complete the
following tasks:
■ Determine the IP address pools and the lease durations to use for each subnet.
■ Obtain the MAC addresses of the clients that require permanent IP addresses.
Determine the IP addresses to use for these clients.
■ List the IP addresses that are available for the servers and routers on your
network—DNS, NetBIOS servers, boot servers, and gateway routers, for example.
■ Determine the DHCP options required by the subnets and clients in your network.
Configuring the DHCP Server with Quick Configuration
The DHCP Quick Configuration pages allow you to configure DHCP pools for subnets
and static bindings for DHCP clients. If DHCP pools or static bindings are already
configured, you can use the Configure Global DHCP Parameters Quick Configuration
page to add settings for these pools and static bindings. Settings that have been
previously configured for DHCP pools or static bindings are not overridden when
you use the Configure Global DHCP Parameters Quick Configuration page.
Figure 8 on page 67 through Figure 10 on page 69 show the DHCP Quick
Configuration pages.
66 ■ Before You Begin
J-series™ Services Router Administration Guide

Juniper J-Series Specifications

General

Brand	Juniper
Model	J-Series
Category	Network Router
Language	English