Juniper J-Series Administration Guide

Table 123: CLI traceroute monitor Command Output Summary
DescriptionField
Hostname or IP address of the Services Router issuing the traceroute monitor command.host
Size of ping request packet, in bytes.
psizesize
Keys
Displays the help for the CLI commands.
Press H to display the help.
Help
Toggles the display mode.
Press D to toggle the display mode
Display mode
Restarts the traceroute monitor command.
Press R to restart the traceroute monitor command.
Restart statistics
Sets the order of the displayed fields.
Press O to set the order of the displayed fields.
Order of fields
Quits the traceroute monitor command.
Press Q to quit the traceroute monitor command.
quit
Packets
Number of the hop (router) along the route to the final destination host.number
Hostname or IP address of the router at each hop.
Host
Percent of packet loss. The number of ping responses divided by the number of ping
requests, specified as a percentage.
Loss%
Pings
Number of ping requests sent to the router at this hop.
Snt
Most recent round-trip time, in milliseconds, to the router at this hop.
Last
Average round-trip time, in milliseconds, to the router at this hop.
Avg
Shortest round-trip time, in milliseconds, to the router at this hop.
Best
Longest round-trip time, in milliseconds, to the router at this hop.
Wrst
Standard deviation of round-trip times, in milliseconds, to the router at this hop.
StDev
Tracing Multicast Routes from the CLI
Use CLI mtrace commands to trace information about multicast paths. The mtrace
from-source command displays information about a multicast path from a source to
240 ■ Using CLI Diagnostic Commands
J-series™ Services Router Administration Guide

Juniper J-Series Specifications

General

Brand	Juniper
Model	J-Series
Category	Network Router
Language	English