Juniper J-Series Administration Guide

show services nat pool
Table 75 on page 143 summarizes key output fields in NAT displays.
Table 75: Summary of Key NAT Output Fields
ValuesField
NAT Pools
Name of the NAT pool.NAT Pool
Lower address in the NAT pool address range.Pool Start Address
Upper address in the NAT pool address range.Pool Address End
Upper port in the NAT pool port range.Port High
Lower port in the NAT pool port range.Port Low
Number of ports allocated in this NAT pool.Ports In Use
Monitoring DHCP
A Services Router can operate as a DHCP server. To view information about dynamic
and static DHCP leases, conflicts, pools, and statistics, select Monitor>DHCP in the
J-Web interface or enter the following CLI commands:
■
show system services dhcp binding
■
show system services dhcp conflict
■
show system services dhcp pool
■
show system services dhcp statistics
In addition, you can display the globally configured DHCP settings by using the show
system services global command from the CLI.
Table 76 on page 143 summarizes the output fields in DHCP displays.
Table 76: Summary of DHCP Output Fields
Additional InformationValuesField
DHCP Leases
List of IP addresses the DHCP server has assigned to
clients.
Allocated
Address
Corresponding media access control (MAC) address
of the client.
MAC
Address
Using the Monitoring Tools ■ 143
Chapter 7: Monitoring the Router and Routing Operations

Juniper J-Series Specifications

General

Brand	Juniper
Model	J-Series
Category	Network Router
Language	English