Juniper JUNOSE 11.2.X MULTICAST ROUTING User Manual

CHAPTER 4
Configuring DVMRP
E Series routers support Distance Vector Multicast Routing Protocol (DVMRP) on VRs
to forward multicast datagrams through a network. DVMRP is an interior gateway protocol
that supports operations within an autonomous system, but not between autonomous
systems. The multicast backbone of the Internet, MBone, uses DVMRP to forward
multicast datagrams. This chapter describes how to configure DVMRP on E Series routers;
it contains the following sections:
•
Overview on page 122
•
Platform Considerations on page 123
•
References on page 124
•
Before You Begin on page 124
•
Enabling DVMRP on a VR on page 124
•
Activating DVMRP on an Interface on page 124
•
Configuring DVMRP Limits on page 125
•
Filtering DVMRP Reports on page 126
•
Configuring DVMRP Summary Addresses on page 126
•
Changing the Metric for a Route on page 127
•
Importing Routes from Other Protocols on page 128
•
Specifying Routes to Be Advertised on page 129
•
Preventing Dynamic Route Distribution on page 129
•
Exchanging DVMRP Unicast Routes on page 130
•
Disabling and Removing DVMRP on page 130
•
Clearing DVMRP Routes on page 131
•
Configuring DVMRP Tunnels on page 132
•
Monitoring DVMRP on page 132
121Copyright © 2010, Juniper Networks, Inc.

Juniper JUNOSE 11.2.X MULTICAST ROUTING Specifications

General

Brand	Juniper
Model	JUNOSE 11.2.X MULTICAST ROUTING
Category	Software
Language	English