JVC In-Dash DVD Player KD-LX50R User Manual

33
ENGLISH
STOP
PLAY
Registering your voices for the voice commands
In the User Word mode (“DEMO OFF” — initial setting: when shipped from the factory), you
can use 13 preset Operation Commands and 12 Access Commands.
To use these voice commands in the User Word mode, you have to do the following:
To use the Operation Commands;
1 Select the User Word mode (“DEMO OFF”) (Follow steps 1 to 4 on page 34.)
2 Register your voice into each Operation Command (Follow steps 5 to 11 on pages 34 to
36.)
To use the Access Commands;
1 Select the User Word mode (“DEMO OFF”) (Follow step 1 on page 37.)
2 Select an operation to preset into an Access Command (For operations you can store into
the Access Commands, see page 37.)
3 Register your voice into the Access Command (See pages 38 to 41.)
Registering your own voice for the Operation Commands
In order to use the Operation Commands (see the list on page 32) speaking the commands in
the language you speak, record your own voices for the Operation Commands. The unit
recognizes and accepts the words you have recorded for the Operation Commands.
Before you start...
• Set “VOICE DEMO” to “DEMO OFF.”
Without setting it to “DEMO OFF,” you cannot record your own voices.
• Notice the following;
– You can only use the Operation Command for which you have registered your voice.
– You can register any word you want; however, if it is too short (ex. “Pops”), the System
may not recognize it correctly.
TO BE CONTINUED ON THE NEXT PAGE
EN30-47.KD-LX50R[E]/f 00.3.22, 10:36 AM33

JVC In-Dash DVD Player KD-LX50R Specifications

General

Brand	JVC
Model	In-Dash DVD Player KD-LX50R
Category	Car Receiver
Language	English