JVC In-Dash DVD Player KD-LX50R User Manual

45
ENGLISH
STOP
PLAY
To erase the voice commands
If you want to erase the Access Commands (VOICE 14 to VOICE 25) already stored, or if you
want to erase the registered voice for the Operation Commands (VOICE 01 to VOICE 13),
follow the procedure below.
• An Operation Command cannot be erased but only the registered voice for it is erased.
1 Press and hold VOICE until one of the Access Commands appears on the display.
2 Press + or – until the voice command you want to delete appears on the display. (In this
example, select Access Command number 15.)
3 Press and hold STR (ATT) until the following message appears on the display.
4 Press + to erase the voice command.
If you want to cancel the erasing, press –.
5 Press and hold VOICE again to finish the erasing.
Experiencing the Voice Recognition System
You can experience the Voice Recognition System using the Standard Word mode (voice
demo).
To activate the voice demo, set “VOICE DEMO” to “DEMO ON” by following the
steps described on pages 46 and 47.
By speaking commands for the Operation Commands in English, you can see how the Voice
Recognition System works. For the words you speak, see the list on page 32.
For Operations
See “Basic Procedure” on page 42.
Pronunciation guide for the Standard Word mode (voice demo)
´
´
´
`
Power off [pɑ2 ɔ:f]
Up [Ãp]
Down [dɑn]
Eject [Dékt]
Next [nékst]
´
´
Back [b{k]
CD [sí:dì:]
Changer [TénTD2]
Line in [lɑn ìn]
FM [éfèm]
AM [éèm]
Play [plé]
Stop [stɑp]
´
EN30-47.KD-LX50R[E]/f 00.3.22, 10:36 AM45

JVC In-Dash DVD Player KD-LX50R Specifications

General

Brand	JVC
Model	In-Dash DVD Player KD-LX50R
Category	Car Receiver
Language	English