Initial settings
Register digital / analogue channels on TV. These channels can be edited later.
(In this manual, digital terrestrial broadcasting is indicated as digital channels,
analogue terrestrial broadcasting and analogue cable TV as analogue channels.)
BACK
TV/DTV
If the “JVC” logo does not appear or if you
wish to make changes later
Digital channel settings : “Configuration” (P. 39)
“Installation” (P. 43)
Analogue channel settings : “SET UP” (P. 34)
Set digital channels
Select a language
1 select
2 set
Select the country of installation
Scan digital channels
Register digital channels
1
2
4
5
What is “T-V LINK”?
Connecting the TV to a “T-V LINK”
compatible device allows :
Analogue channels to be instantly
registered on the device.
The “DIRECT REC” function to be
used.
“Technical information” (P. 54)
“T-V LINK” variations
“T-V LINK” (JVC) “Q-LINK” (Panasonic)
“Megalogic” (Grundig) “Data Logic” (Metz)
“SMARTLINK” (Sony) “Easy Link” (Philips)
If digital channels are not found, the following message will appear.
After completing following steps, read “When the TV cannot find the digital
channels” (P. 14) and try scanning digital channels again
Language for on-screen
displays when watching digital
channel including the DTV
menu.
2 next
1 select
!
(Next page)
3
Set the aerial power supply
Only when using an aerial which
needs external power, select “On”.
“Power supply for the indoor
aerial” (P. 55)
To the previous screen
Exit
Begin
The remote control
doesn’t work
Confirm the mode is set to
“TV”.
1
2
Shown only when powering on for the first time.
The power button on the unit can also be used.
Receivable digital channels will
differ depending on the country
setting.
The illustrations are for Finland
1 select
2 set
To Next Page
Loading...
Need help?
General
