JVC MX-D302T User Manual

16
3. Press the number keys (1 to 10 and
+10) to select the track to program.
• Example: for track 5, press 5. For track 15,
press +10 then 5. For track 20, press +10 then 10.
4. Repeat steps 1 to 3 to select the other tracks for the program.
5. Press the £/8 button.
The Unit plays the tracks in the order you have programmed them.
o If you try to program a disc tray that is empty, or a track number that does not exist on a disc (for
example, selecting track 14 on a disc that only has 12 tracks), the selected disc or track are skipped
when the program is played.
o You can skip to a particular program step by pressing the MULTI CONTROL (4/1 P. DOWN or
¢/¡ P. UP) or the 4 or ¢ button on the Remote Control during program play.
o To play the programmed tracks over and over, press the REPEAT button . The Repeat mode indicators
light up in sequence with each press of the REPEAT button.
To stop playing, press the 7 STOP button (or the 7/CLEAR button on the Remote Control) once.
To delete all the tracks in a program, press the 7 STOP button on the Unit or the 7/CLEAR button
on the Remote Control while the CD Player is stopped. The program is deleted and the PRGM indicator
goes out and Normal Play is resumed.
To cancel program play, press the PLAY MODE button on the Remote Control while the CD Player
is stopped to select a different Play mode. The PRGM indicator goes out and the next Play mode is
selected.
Note: If you press the CONTINUE or RANDOM button on the Unit while a program is playing, the
play mode changes to that mode.
Random Play
The tracks will play in no special order when you use this mode.
On the Unit
Press the RANDOM button.
The playback automatically starts from the selected CD.
• “RANDOM” on the Play mode indicator lights up.
You can press the RANDOM button while a CD is playing to switch to Random play mode.
On the Remote Control
1. Press the PLAY MODE button while
the CD Player is stopped, to select
“RANDOM”.
• The RANDOM indicator lights up.
Each time you press the button, CD play mode changes as follows:
= PROGRAM = RANDOM = CONTINUE = No play mode display = (back to the
beginning)
2. Press the £/8 button.
Playback starts from the selected CD.
Note: Random Play cannot be activated with the DISC button (1 to 3) and the number keys.
To skip to the next track, press the ¢/¡ P. UP on the MULTI CONTROL (or the ¢ button on
the Remote Control) during playback. Each time you press the button, the next track is jumped to. Press
the 4/1 P. DOWN on the MULTI CONTROL (or the 4 button on the Remote Control) to jump to
the start of the track being played.
Press the REPEAT button before or during random play to instruct the System to continue with a
different random track selection after the last selection is played.
To cancel random play, press the RANDOM button again. The RANDOM indicator goes out and
Normal Play is resumed. When using the Remote Control, press the PLAY MODE button while the CD
Player is stopped to select a different Play mode. The RANDOM indicator goes off and the next Play
mode is selected.
PRGM
A.BASS EX S.MODE
1
23
456
7
8
9
10
10
CLOCK TIMER
SET
– SELECT +
RANDOM
PLAY MODE
£/8
A.BASS EX S.MODE
RANDOM
EN.MX-D302T[J]/ff 98.1.16, 4:11 PM16

JVC MX-D302T Specifications

Amplifier Section

output power	55 watts per channel
input sensitivity	300 mV
input impedance	50 kohms

Cassette Deck Section

frequency response Type II	50 - 14, 000 Hz
frequency response Type I	50 - 14, 000 Hz
wow and flutter	0.15% (WRMS)

CD Automatic Changer Section

cd capacity	3 discs
dynamic range	85 dB
signal-to-noise ratio	90 dB

Tuner Section

fm tuning range	87.5 - 108.0 MHz
am tuning range	530 - 1, 710 kHz
dimensions	265 × 315 × 340 mm

Speaker Specifications

tweeter size	5 cm
woofer size	12 cm
power handling capacity	60 W

Power Specifications

power requirements	AC 120 V, 60 Hz
power consumption	95 watts
standby power consumption	9 watts

Weight and Dimensions

dimensions	265 × 315 × 340 mm
mass	7.2 kg
speaker dimensions	215 × 315 × 230 mm