JVC MX-D302T User Manual

20
Using the Cassette Deck
(Recording)
DISC
DISC
DISC
REPEAT
RANDOM
CONTINUE
CD REC START
REC START/STOP
DUBBING
1
23
456
7
8
9
ACTIVE
BASS EX.
REC PAUSE
10
10
FM/AM
A
B
DISC
FM MODE
PLAY MODE
7 /CLEAR £/8
DISC
DISC
VOLUME
SHIFT
SOUND
MODE
SLEEP
POWER
RM-SE40TU
REMOTE CONTROL
AUX
C D
DECK
CLOCK TIMER
SET
– SELECT +
REC PAUSE
Things to Know before You Start Recording ———————
o It should be noted that it may be unlawful to re-record pre-recorded tapes, records, or
discs without the consent of the owner of copyright in the sound or video recording,
broadcast or cable programme and in any literary, dramatic, musical, or artistic
embodied therein.
o When you want to record onto both sides of a tape, you can set the auto reverse mode on to do so.
However, recording automatically stops after recording in the 2 direction in the auto reverse mode.
Therefore, make sure that the tape direction is 3 when recording with the auto reverse mode on.
o The recording level, which is the volume at which the new tape is being made, is automatically set
correctly, so it is not affected by the VOLUME control on the System. Thus, during recording you can
adjust the sound you are actually listening to without affecting the recording level.
o Two small tabs on the back of the cassette tape, one for side A and one for side B, can be removed to
prevent accidental erasure or re-recording. To record on a cassette with the tabs removed, you must
cover the holes with adhesive tape first.
However, when a Type II tape is used, only cover part of the hole as shown, since the other part of the
hole is used to detect the tape type.
o When recording, you can hear Sound Mode effects through the speakers or headphones. However, the
sound is recorded without Sound Mode effects.
o Type I and Type II tapes can be used for recording.
Note: At the start and end of cassette tapes, there is leader tape which cannot be recorded onto. Depend-
ing on the recording source, the first part of the recording may be missing because of the leader. When
recording CDs or radio broadcasts, to get the beginning of the recording on the tape, first wind on the
leader before beginning recording.
Display
kHz
MHz
CONT.
ALL PRGM
REC
A.BASS EX S.MODE
SLEEP MONO STCLOCK
RANDOM
REC indicator
When the System is being used, the display shows other items as well.
However, we have only shown the items described in this section.
EN.MX-D302T[J]/f 98.1.13, 5:06 PM20

JVC MX-D302T Specifications

Amplifier Section

output power	55 watts per channel
input sensitivity	300 mV
input impedance	50 kohms

Cassette Deck Section

frequency response Type II	50 - 14, 000 Hz
frequency response Type I	50 - 14, 000 Hz
wow and flutter	0.15% (WRMS)

CD Automatic Changer Section

cd capacity	3 discs
dynamic range	85 dB
signal-to-noise ratio	90 dB

Tuner Section

fm tuning range	87.5 - 108.0 MHz
am tuning range	530 - 1, 710 kHz
dimensions	265 × 315 × 340 mm

Speaker Specifications

tweeter size	5 cm
woofer size	12 cm
power handling capacity	60 W

Power Specifications

power requirements	AC 120 V, 60 Hz
power consumption	95 watts
standby power consumption	9 watts

Weight and Dimensions

dimensions	265 × 315 × 340 mm
mass	7.2 kg
speaker dimensions	215 × 315 × 230 mm