10
Stand (supplied)
Side panel of the main unit
From a USB mass storage class device
When connecting a USB mass storage class device
• When connecting with a USB cable, use the USB 2.0 cable whose length is less than 1 m.
• You can connect a USB mass storage class device such as a USB flash memory device, hard disk drive, multimedia card
reader, etc. to this System.
• You cannot connect a computer or JVC Everio camcorder to the USB MEMORY REC/PLAY terminal (
) of the
System.
• Electrostatic shock at connecting a USB device may cause abnormal playback of the device. In this case, disconnect the
USB device then reset this System and the USB device.
See page 18.
See page 37.
To attach the supplied stand to the main unit
When placing the main unit vertically, make sure to attach the supplied stand to the main unit. Attach the supplied stand
firmly to the back of the main unit after connections have been completed.
CAUTION:
Detach the stand before carrying the main unit.
EN_NX-T10[UG]_CS2.indb 10EN_NX-T10[UG]_CS2.indb 10 09.12.14 9:53:09 PM09.12.14 9:53:09 PM
To Next Page
Loading...
Need help?
General
