17
Daily Operations—Playback
In this manual, operations using the remote control
are mainly explained; however, you can use the buttons
and controls on the main unit if they have the same (or
similar) name and marks.
1 Turn on the power.
The lamp on the main unit lights blue.
• The POWER ON/STANDBY lamp on the
subwoofer also lights blue.
• Instead of pressing
, the System is turned on by
pressing one of the following buttons:
– DVD/CD, HDMI 1/2, INPUT, FM, SOURCE, 3,
0
2 Select the source.
From the Remote control
• For disc: Press DVD/CD. See page 19.
• For FM: Press FM. See page 18.
• For HDMI 1/2: Press HDMI 1/2 repeatedly to select
“HDMI 1” or “HDMI 2.” See page 21.
• For USB/DIGITAL IN/AUDIO IN:
Press INPUT repeatedly to select “USB,” “DGTL
IN,” or “AUDIO IN.” See pages 19 and 21.
On the Main unit
Pressing SOURCE repeatedly changes the source as
follows:
• You can change the display information by pressing
DISPLAY. For details, see page 23.
3 Adjust the volume.
You can adjust the volume level from “VOL MIN”
(level 0) to “VOL MAX” (level 60).
To turn off (standby) the System
The lamp on the main unit lights red.
• The POWER ON/STANDBY lamp on
the subwoofer also lights red.
• A small amount of power is always
consumed even while on standby.
DO NOT turn off (standby) the System
with the volume set at an extremely high
level; otherwise, the sudden blast of sound
may damage your hearing, speakers and/or
headphones when you turn on the System or
start playback.
Remote control
Number
buttons
Main unit
or
or
EN_NX-T10[UG]_CS2.indb 17EN_NX-T10[UG]_CS2.indb 17 09.12.14 9:53:12 PM09.12.14 9:53:12 PM
To Next Page
Loading...
Need help?
General
